7/5/2023 0 Comments Projektor lift![]() ![]() The lift moves very gently and quietly to the desired position. Sophisticated bearing technology prevents movements of all kinds. This is exactly what our X-Lift prevents. It is particularly important that projectors are moved gently. Thanks to the stable and light scissor joints, the lift retracts completely into the ceiling. On request you can connect an EIB bus, Loxone, roller shutter switch or much more! Optionally, plasterboard panels can be attached to the lower side of the ceiling lift. Not only can they be subjected to high loads, but they also do not warp under high loads. The storage and mounting surfaces are made of 6 mm thick aluminium. The recessed motor unit gives us maximum space in the lift. Additional suspended ceilings are not required with our system. We recommend rubber feet to turn the projector upside down. The projector can be mounted either inside or below the lift. ![]() At the touch of a button, the lift can be extended and the projector put into operation. Your living room or office looks tidy and the projector is protected from access. When retracted, the projector becomes invisible. Ultrasonic slim with backed out motor unit With an installation height of only 12.5 cm, it can extend up to 80 cm. Despite its smooth running, the motor has a fast lifting speed (15 rpm). The safe 230 Volt / 120 Watt tube motor has a quiet and easy run and is whisper quiet in operation which is not only due to the stable and wide belt system. All you need to do is plug the 230Volt plug into the floor socket and you can set the lift in motion. As a standard we supply a radio receiver and radio transmitter. It is also possible to control it via a projector tricker output via relay. Anchor Projector Lift offers the innovation, modern design to fit any room or auditorium, Full Cable management system, connect control module, ceiling edge. The drive motor can be precisely limited at the upper entrance and exit. 40NM Jaro Lift motors can move up to 80 kg and exceed by far the maximum demand on the lift. They are extra oversized and therefore run completely noiseless. We use exclusively German high quality bearings from Igus. Service hotline for technical questions Mon-Fri from 09.00-18.00 hrs +49 40 2263904 11 Please use a roller shutter or jalousie switch for this purpose.ฤก x packaging extra-strong foamed for safe transport Suitable for all types of house control, such as GIRA, LOXONE, KMX etc. Housing colour: Silver (traces of processing may occur).Projector attachment: In or under the lift.Footprint Inner dimension Width (with cable guide): 39.5 cm.Shelf inside dimension Width (without cable guide): 42.5 cm.Exit depth or opening depth of the floor unit: 40 cm.Extension width or opening width of the base unit: 53 cm.Projector lift: 60 cm lifting height, footprint 42,5 cm, mounting height only 12.5 cm ![]()
0 Comments
Leave a Reply. |